10 pcs Hirobo HI2525008 EX D5mm Ball with Stand  [HI2525008]

HIROBO 2525-008 EX D5MM BALL WITH STAND 2 10PCS #2525008
Price:
NZD$13.25
Brand:
Hirobo
Model:
HI2525008
GTIN:
4512895128531
Condition:
Brand New
Write a review

Compact D5mm ball with stand, pack of ten

This aftermarket pack supplies ten EX D5mm ball with stand units from Hirobo, aimed at servicing small RC helicopter linkages and restoring worn control connections. The items are offered as a service kit to refresh ball joints used in rotor and control link assemblies.

Design role: the D5mm ball with stand creates a low-profile joint where space is constrained; it serves as a replaceable bearing point between rods and control arms to lessen slop and recover precise input translation.

Installation advice: inspect the receiving sockets and linkage pins for wear before installation, swap in matched pairs where balance is important, and ensure the stand sits firmly in the arm or bracket. Standard RC hand tools suffice for fitting, and the ten-piece count covers multiple replacements or spare stock for outings.

Are these the exact replacement parts?

These are EX D5mm ball with stand items produced to match the same form and function used in Hirobo linkages; confirm fitment against your existing parts.

What materials and durability can I expect?

The parts are intended for routine linkage service; inspect them regularly for wear. Durability will depend on use conditions and maintenance.

Should I replace both sides at once?

For symmetrical controls it is recommended to replace matched items together to maintain balanced geometry and consistent control feel.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved