1000mm Purple Antenna Cord for RC Receivers - Futaba FUAL0140  [FUAL0140]

FUTABA FM RECEIVER ANTENNA CORD CALBE WIRE PURPELE 1000MM AL0140 (W/O PACKING)
Price:
NZD$5.16
Brand:
Futaba
Model:
FUAL0140
Condition:
Brand New
Write a review

FM Antenna Replacement Lead

The Futaba FUAL0140 antenna cord serves as a direct replacement lead for Futaba FM receivers in RC models. The single 1000mm purple conductor gives a clear, manageable length so the antenna can be routed inside the chassis where the stock lead is missing or compromised.

Keep the antenna away from motors, ESC power wiring, and any sharp chassis edges that could abrade the insulation. Use gentle routing paths and leave a small service loop to accommodate chassis flex without stressing the wire.

Before trimming, mark the length and cut only after confirming fit. Secure routing with existing clips or mounts and carry out a range check after installation to ensure dependable reception before operating the model outdoors.

It is made for Futaba FM receivers and other FM systems that use an external lead. Check your receiver wiring to confirm compatibility before installing.
No. The purple insulation is purely cosmetic. Performance depends on routing and avoiding sources of interference rather than the wire color.
Use existing chassis clips or small zip ties, and leave a short service loop near the receiver to prevent strain when components move.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved