10J/10M/10D Engine Thermal Isolation Plate - O.S. Engine OS21165010  [OS21165010]

O.S. ENGINES THERMO INSULATOR 10J,10M,10D
Price:
NZD$16.78
Brand:
O.S. Engine
Model:
OS21165010
GTIN:
4531028135154
Condition:
Brand New
Write a review
alt="O.S. ENGINES THERMO INSULATOR 10J,10M,10D" title="O.S. ENGINES THERMO INSULATOR 10J,10M,10D"

Heat control component for RC glow units

The OS21165010 thermo insulator serves as a passive thermal barrier for models equipped with 10J, 10M, and 10D engines, reducing unwanted heat conduction at contact points. It helps preserve consistent thermal conditions that can affect mixture and running behavior without altering engine internals.

Use the part to separate hot surfaces from sensitive chassis elements or nearby fittings, aiding repeatable test runs and setup checks. It is a thin insulating element and should be used alongside, not in place of, normal cooling or exhaust hardware.

Before installation, confirm exact fit to your engine layout, ensure there is no contact with moving parts, and check exhaust and cooling clearances. Expect incremental changes to behaviour and verify tuning after installation.

Can this insulator handle prolonged high temperatures?

It is designed as a passive thermal barrier for engine mounting areas; while it reduces local heat transfer it does not act as an active cooling device, so monitor for any degradation if exposed to extreme conditions.

Where should I position it for best effect?

Place it between the engine contact surfaces and the chassis or adjacent fittings where heat conduction is most likely; confirm alignment and clearances prior to final tightening.

Does it replace cooling components?

No. The insulator reduces conductive heat transfer but does not substitute for radiators, cooling fins, or proper muffler arrangements.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved