1/10 Drift Setup Wrench 8mm Steel - Yokomo YT-303  [YT-303]

Compact 8mm spanner designed for turnbuckle work

This 8mm steel spanner is intended as an RC setup tool for turnbuckles, rod ends and other small hex nuts found on 1/10 touring and drift chassis. Its fixed 8mm face gives consistent contact on flats when making fine suspension or toe changes.

Use notes: best suited for setup tasks such as trimming toe-in/out, tweaking tie-rods and correcting minor alignment after component swaps. Always hold the counter nut or support the adjacent part to avoid transmitting torque into delicate suspension pieces.

Tool care: clean the wrench face after use and keep it in a tool roll to prevent misplacement. Periodic checks for burrs or wear will keep adjustments accurate. This item is for model maintenance only and is not suitable for full-size vehicles.