11x3.8SFP APC Propeller AP11038SFP for Reverse/Pusher Electric Slow-Flyers  [AP11038SFP]

APC PROPELLER 11x3.8SFP ELECTRIC SLOW FLYER REVERSE/PUSHER
Price:
NZD$7.72
Brand:
APC
Model:
AP11038SFP
Condition:
Brand New
Write a review

Blade balance and handling with the APC 11x3.8SFP

The APC AP11038SFP propeller is produced for RC slow-flyer aircraft configured in pusher or reverse arrangements. It is intended to assist in tuning thrust distribution and maintaining steady handling during low-speed flight typical of sport and scale models.

Ensure you only fit this prop to compatible motor shafts and the correct prop adapter. Before flying, check thread orientation for your mounting style, secure the hub properly, and balance the blade set to minimize vibration. Confirm the prop has sufficient clearance from fuselage and control surfaces in rear-mounted installations.

Because this prop affects pitch response and thrust placement, small changes in blade selection or location can change trim and control authority at low speeds. Conduct measured flight trials and use standard safety precautions while performing ground and flight tests.

How critical is balancing for this APC prop?

Balancing is essential for smooth operation and to protect bearings and gearboxes. Even small weight differences between blades can produce vibration; balance on a quality balancer and correct minor imbalances before flight.

Can I repair small nicks or must I replace the blade?

Minor surface nicks may be smoothed carefully, but any damage that alters blade mass or shape should be treated as a replacement case. Do not fly props with cuts or deep dents that affect balance or structural integrity.

How often should I recheck balance and mounting?

Check balance after any impact, after changing adapters or shafts, and as part of routine maintenance. Also perform a quick visual and fastening check before each flying session.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved