11x8EP APC AP11080EP Electric Pusher/Reverse Propeller  [AP11080EP]

Installation and performance notes

The APC AP11080EP propeller is crafted for electric reverse or pusher configurations on RC models. Its 11x8 profile shifts the emphasis toward thrust at higher RPMs rather than low-RPM torque, and the reinforced composite blades provide consistent performance under load.

Installation notes: confirm your shaft and adapter dimensions before fitting, tighten the mounting nut to the adapter maker's guidance, and orient the propeller so blade pitch produces thrust in the intended pusher or reverse direction. Verify rotation with the motor and ESC before the first operation.

Tuning guidance: consider motor Kv and ESC limits when choosing this 11x8 prop; diameter and pitch control static thrust and cruising RPM, so match to a setup that reaches higher RPM ranges. Always balance and inspect blades for damage after use to maintain predictable handling.

Safety and maintenance: balance the prop prior to runs, retire props with chips or cracks, and maintain a safe exclusion zone during engine start. Apply recommended locking hardware or thread locker when applicable for your hub system.