13mm Rod End +3 Offset Pack (4 pcs) - Serpent 500897  [SER500897]

Serpent SER500897 Shock 13mm rod end +3
Price:
NZD$0.00
Brand:
Serpent
Model:
SER500897
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

13mm Rod End, Offset +3

The Serpent 500897 rod end is a replacement component intended for RC dampers that take 13mm style rod ends. Supplied as a +3 offset set of 4 pcs, it is used where a slightly increased rod-end projection is required to modify linkage or preload settings.

Installation uses conventional damper servicing steps: remove the old rod end, fit the +3 unit and verify correct thread engagement and smooth articulation. Typical workshop tools such as hex keys and pliers will suffice; this is an aftermarket part for suspension tuning on scale models.

As a tuning tool, the +3 option changes the effective link length and can affect roll center and shock leverage. Make incremental changes and record handling effects to build a setup baseline.

How does the +3 variant compare to standard rod ends?

The +3 version increases the rod end offset by three units relative to the standard length, producing a modest change in linkage geometry without altering mounting points.

Is the pack size suitable for a full setup?

Yes. The pack contains 4 pcs, which is typically enough to replace multiple rod ends across a single model or to carry as spares.

Do I need to change spring or damping settings after fitting?

You may need small adjustments to spring preload or damping to compensate for the altered leverage. Make one change at a time and test to judge handling differences.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved