13mm +2 Shock Ball End Set (4) for SRX - Serpent 500896  [SER500896]

Durable 13mm rod ends for SRX shocks

The Serpent 500896 Shock 13mm rod end +2 is supplied as a four-piece replacement kit intended for SRX shock assemblies. These rod ends introduce a +2 offset at the 13mm connection point and are aimed at fine-tuning geometry while leaving shock internals untouched.

Fitment notes: experienced technicians should remove the existing link or lower collar, swap in the 13mm +2 rod end, and verify the joint articulates freely across the suspension travel. The components are made to interface with standard RC shock ball studs and common link hardware; confirm thread depths and ball stud fit prior to final tightening.

Service and wear: these rod ends are handy when evaluating incremental changes without increasing wear on shock shafts or pistons. Keep an eye on articulation points and replace any parts that show excessive play to maintain consistent damping response.

Carry spare rod ends during testing to swap quickly between runs, and inspect each pivot point for smooth movement after installation.