150mm i-Connector Lead for SVi to Receiver - Futaba FUEBB0153  [FUEBB0153]

FUTABA 150MM i-CONNECTOR CORD CABLE SVi TO RECEIVER 30-STRAND WIRE EBB0153
Price:
NZD$9.20
Brand:
Futaba
Model:
FUEBB0153
GTIN:
4513886306921
Condition:
Brand New
Write a review

i-Connector lead for SVi connections

This Futaba FUEBB0153 lead is made for connecting SVi-capable modules directly to a receiver using an i-Connector plug. Marked as 150mm in length and built from a 30-strand conductor set, it balances flexibility with a slim footprint so it fits cleanly in most model bays.

Choose this lead where a direct SVi-to-receiver hookup is needed without extra adapters. The stranded construction helps the cable conform around mounts and components, and the shorter length is suitable for compact and medium-sized models where tidy signal runs matter.

To install, mate the i-Connector to the SVi output of compatible Futaba modules and insert the other end into the intended receiver channel. Keep the cable clear of thick motor leads and anchor it lightly so it does not obstruct moving parts. The lead is intended to maintain short, well-ordered signal paths during setup and adjustments.

Why pick a 30-strand cable for compact radio bays?

A 30-strand construction yields greater pliability than thicker single-core wires, letting you route the cable through tight spaces and around components with minimal stress on the conductor.

How can I confirm correct connector orientation when plugging in?

Check the plug keying and pin labels on both the module and receiver before insertion; a visual check of pin alignment prevents reversed connections and ensures proper signal mapping.

Is this lead suitable for other SVi-output modules?

It is intended for SVi-to-receiver links and will work with other modules that follow the same i-Connector pinout, but always verify compatibility of the connector type and pin orientation before relying on it.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved