15T MG215T/0.5M Motor Pinion (0.5mm module, 2.2mm bore) by GPM [MG215T/0.5M]

40Cr Steel Motor Gear 15T ( Module:0.5mm, Motor Tooth Diameter:2.2mm) - GPM MG215T/0.5M

Price:

NZD$13.54

Brand:

GPM

Model:

MG215T/0.5M

GTIN:

4894538411508

Condition:

Brand New

Color Available:

Quantity:

Write a review

Description
FAQ

Installation Notes for 15T Pinion

The MG215T/0.5M pinion fits motors that share a 0.5mm module and a 2.2mm motor bore; the round hole accepts standard shafts of that diameter and the 15-tooth layout suits compact drivetrains.

Produced from heat-treated 40Cr steel for improved wear resistance, the pinion secures to the shaft with two 3x3 set screws. Proper installation technique avoids misalignment and maintains gear life.

Practical installation advice:

Verify module and bore dimensions before fitting to avoid mismatches.
Clean the shaft and align the gear, then tighten the two set screws alternately for even seating.
This part is intended for RC model transmissions; check gear ratio implications before swapping pinions.

What tools and preparation are required to fit this pinion?

A small hex driver for the 3x3 set screws and basic cleaning tools are all that is required. Ensure the shaft is free of grease and burrs before assembly.

How should the set screws be tightened during installation?

Tighten the screws alternately and evenly until snug. Avoid over-torquing to prevent stripping the screws or damaging the shaft.

Any tips to prevent pinion slippage?

Make sure the shaft is straight and clean, align the pinion accurately, and clamp both set screws evenly to reduce chances of slippage.