18x6 Laminated Wood Propeller MA1860B for RC Scale Aircraft by Master Airscrew  [MA1860B]

MASTER AIRSCREW WOOD SERIES 18x6 PROPELLER
Price:
NZD$36.72
Brand:
Master Airscrew
Model:
MA1860B
Condition:
Brand New
Write a review

Product highlights for the 18x6 wooden prop

The Master Airscrew MA1860B 18x6 propeller is crafted from laminated wood to provide the visual appeal and damping qualities associated with wooden props, while remaining compatible with electric and nitro model setups that accept wood blades.

The designation 18x6 describes the propeller diameter and pitch; it is intended for uses that call for an 18-inch diameter and approximately 6-inch pitch. Always confirm hub and shaft adapter compatibility and carry out static balancing after installation to reduce vibration and protect your model.

Specifications

  • Item: 18x6 wooden propeller
  • Material: laminated wood
  • Model Number: MA1860B
  • Compatibility: RC-scale model aircraft general use

This propeller functions as a reliable wooden replacement or upgrade for pilots seeking the feel of wood; confirm hub fitment, balance once fitted, and match pitch and throttle response to your motor and ESC for best results.

How does the 18x6 size influence flight characteristics?

The 18-inch diameter affects thrust and ground clearance, while the 6-inch pitch affects theoretical forward travel per revolution. Select based on aircraft weight, drag and motor RPM.

Should I finish the wood before flying?

If you expect moisture or wear, a light protective finish can extend life. Ensure finishes are thin and evenly applied to avoid imbalance.

What inspection routine is recommended?

Inspect for nicks, cracks or delamination before each flight and after any hard landing; replace if damage is present to avoid failure in flight.

Any advice on hub adapter selection?

Confirm the hub bore matches your shaft or use a correct adapter; a snug, concentric fit prevents wobble and simplifies balancing.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved