23T 0.5mm Module Motor Pinion MG323T/0.5M by GPM  [MG323T/0.5M]

40Cr Steel Motor Gear 23T ( Module:0.5mm, Motor Tooth Diameter:3.175mm) - GPM MG323T/0.5M
Price:
NZD$13.54
Brand:
GPM
Model:
MG323T/0.5M
GTIN:
4894538411478
Condition:
Brand New
Write a review

Precision 23T 0.5mm Module Pinion

This MG323T/0.5M motor gear is supplied as an RC replacement pinion for motors that meet the stated dimensions. It incorporates a 0.5mm module, 23 teeth and a motor tooth diameter of 3.175mm, finished in a hardened black coating to reduce wear.

Fitment notes: the gear uses a round motor bore matched to the specified motor tooth diameter and fastens with two 3x3 set screws to the shaft. Before fitting, check the module, tooth count and shaft interface to ensure the part mates correctly with your spur gear.

Tuning and setup: this pinion suits fine adjustments to drive ratios where modest tooth count or material changes impact engagement, wear characteristics and transmission feel. Confirm matched specifications for dependable gear meshing.

What is the recommended installation procedure?

Slide the pinion onto the motor shaft, align the gear mesh with the spur, then tighten the two 3x3 set screws evenly. Recheck mesh under slight load.

Will the hardened finish need a break-in period?

No special break-in is required; however, verify gear mesh and run the model gently for a short period while monitoring noise and wear.

Are replacement set screws a standard size?

The unit uses two 3x3 set screws. Equivalent metric replacements are commonly available from hobby suppliers or hardware stores.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved