25mm Coil Spring (Hard, Green) for 1/10 Drift and Touring — Yokomo YOKD119G  [YOKD119G]

Performance-Tuned 25mm Coil for 1/10 Cars

This 25mm coil spring is provided as a single tuning item for 1/10 scale drift and touring models. The green marking signals a harder rate and the component is sold on its own rather than as part of a shock kit.

Use the spring to tighten cornering feel and limit chassis roll on low-grip surfaces used in slide setups. The harder spring increases load transfer and alters the balance between compression and rebound when combined with your current shock pistons and oil choice.

Installation mirrors other 25mm free-length springs: slide onto the shock shaft or seat, set the correct preload to match your desired ride height, then assess performance with short runs. For stable results, swap matched pairs or change one corner at a time to judge handling changes.

Consider this item as part of an overall tune for a 1/10 chassis; verify your model accepts 25mm free-length springs and include shock oil, piston selection, and roll bar configuration in your setup plan.