300mm SVi i-Connector Cable for Servo-to-Receiver by Futaba FUEBB0155  [FUEBB0155]

300mm SVi i-Connector Cable

This Futaba FUEBB0155 300mm i-Connector cord is made to join SVi-capable servo outputs to the receiver while maintaining a tidy wiring layout inside model radio bays. The 30-strand conductor emphasises flexibility, allowing the cable to be routed through tight spaces behind servo mounts.

Compatibility is limited to SVi-style signal connections; check your receiver and peripherals for SVi support prior to fitting. The cable length and fine-strand construction ease stress on connector solder points and keep the wiring neat without unnecessary bulk.

Fitting advice: follow the existing harness routes, avoid sharp kinks at plug ends, and anchor the cord with light tape or small ties to prevent abrasion against chassis panels. For high-frequency digital servos, confirm connectors are fully inserted and monitor for any signal disturbances from nearby high-current wiring.

Use case: this component serves as a wiring aid rather than a performance upgrade; tidy installation helps preserve consistent servo operation during setup and calibration.