3Racing GRAP-1008 Woven Graphite Sheet 0.8mm Chassis Plate  [GRAP-1008]

3RACING 0.8mm Woven Graphite Plate (0.8 x 200 x 450mm) - GRAP-1008
Price:
NZD$58.46
Brand:
3Racing
Model:
GRAP-1008
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Upgrade Chassis Stiffness with 3Racing GRAP-1008

The 3Racing 0.8mm Woven Graphite Plate is a handy material for model makers aiming to fine tune handling. It offers a lightweight way to reduce chassis flex and protect critical mounting points without adding bulk.

How the 3Racing Plate Helps Handling

With its woven fibre layout, the 3Racing 0.8mm Woven Graphite Plate resists stretching and localised deformation. The 200 x 450mm panel is large enough to cut multiple small parts or larger reinforcements and retains excellent stiffness for cornering loads.

Specifications

  • Material: Woven Graphite
  • Thickness: 0.8mm
  • Dimensions: 200 x 450mm
  • Application: RC Model Construction

For racers and dedicated hobbyists, this graphite plate is a lightweight route to stronger, more consistent setups.

Will this plate change ride characteristics?

Adding graphite to key areas typically reduces flex and can make steering response crisper. Changes are controllable with selective placement rather than full chassis replacement.

Is the plate safe for soldering electronics to?

Graphite is conductive and not suitable as a soldering surface. Use insulated pads or mount electronics on nonconductive standoffs when necessary.

How should I seal cut edges to prevent fraying?

Light sanding followed by a small bead of epoxy or a thin cyanoacrylate coat will seal edges and help prevent delamination when exposed to vibration.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved