3Racing GRAP-1025 Precision 2.5mm Woven Graphite Sheet  [GRAP-1025]

3RACING 2.5mm Woven Graphite Plate (2.5 x 200 x 450mm) - GRAP-1025
Price:
NZD$101.36
Brand:
3Racing
Model:
GRAP-1025
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Precision Graphite Sheet for RC Fabrication

The 3Racing GRAP-1025 is a 2.5mm woven graphite panel measuring 200mm by 450mm, intended for builders crafting bespoke components or strengthening chassis sections. Its woven fibre pattern provides consistent stiffness and manageable weight for tunable handling.

Why Woven Graphite Works Well

Woven graphite offers a predictable stiffness profile and a high stiffness-to-mass ratio, making it a go-to material for modders. The GRAP-1025 combines rigidity and lightness so you can add reinforcement without compromising acceleration or balance.

Practical Applications

  • Custom Chassis: Cut profile plates to support specific motor and battery placements.
  • Reinforcement: Add structural patches in high-stress zones with minimal weight penalty.
  • Modular Use: Trim and slot the sheet to suit roll cages, braces, and body mounts.

How do I avoid fraying when trimming the sheet?

Score the surface first, use sharp blades and backing support, and apply masking tape along cut lines to reduce fibre lift before final trimming.

Is the material electrically conductive?

Yes, woven graphite is conductive. Keep that in mind near electronics and battery terminals and insulate contact points where needed.

Can I paint or finish the surface?

Prepare the surface with a light scuff, use a primer suitable for composites, and finish with flexible paint or decal film to avoid cracking at cut edges.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved