3RACING 3RAC-HKS30/RE Red 3.0mm Servo Arm for Ko Propo Sanwa  [3RAC-HKS30/RE]

3RACING 3.0mm Aluminium Single Servo Arm For Ko Propo/Sanwa - Red - 3RAC-HKS30/RE
Price:
NZD$6.11
Brand:
3Racing
Model:
3RAC-HKS30/RE
Condition:
Brand New
Write a review

Compact 3RACING 3RAC-HKS30/RE Arm to Tighten Steering

The 3RACING 3RAC-HKS30/RE 3.0mm aluminium single servo arm is aimed at hobbyists who want crisper steering without adding bulk. Finished in red anodize, it pairs cleanly with Ko Propo and Sanwa servos for a tidy upgrade.

Durable Aluminium for Consistent Inputs

Made from anodized aluminium, this 3.0mm arm resists bending under load and holds a solid feel through repeated use. Its light weight helps preserve your vehicle's balance while improving control feedback.

Quick Swap and Broad Fitment

Compatible with many Ko Propo and Sanwa servo horns used in 1/10 scale cars, the arm fits using common hardware and requires minimal setup changes. The red colour also makes it easy to identify during bench work.

Do I need special tools to install this arm?

No special tools are required beyond basic hex drivers or screwdrivers used for servo horns. Make sure screws are torqued evenly to avoid binding.

Will the red anodize wear off quickly?

Anodize is durable but can show marks from impacts or heavy use. Regular inspection and careful handling will keep it looking good for many sessions.

Can this arm be used on off road buggies?

Yes, it suits many 1/10 off road and on road models that accept Ko Propo or Sanwa servo horns, provided the servo spline and screw pattern match.

Should I upgrade other steering parts at the same time?

Upgrading tie rods or ball ends can complement a stiffer servo arm to improve overall steering precision. Check geometry after swapping parts to maintain alignment.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved