3RACING 3RAC-PG4847 47T 48 Pitch Hard Coated Pinion (7075 Aluminium)  [3RAC-PG4847]

3RACING 48 Pitch Pinion Gear 47T (7075 w/ Hard Coating) - 3RAC-PG4847
Price:
NZD$7.56
Brand:
3Racing
Model:
3RAC-PG4847
Condition:
Brand New
Write a review

Precision pinion for 1/10 scale models

The 3RACING 48 Pitch 47T Pinion Gear is a practical upgrade for hobbyists who want consistent performance. Crafted from 7075 aluminium with a protective hard coating, it is aimed at reducing tooth wear while keeping engagement smooth.

Designed for endurance and smooth running

The 7075 aluminium body delivers strength and good fatigue resistance, and the hard coating helps the gear run cleaner against the spur and motor pinion. This reduces maintenance frequency for regular track use.

Fits a broad selection of 1/10 chassis

With a 47 tooth count on a 48 pitch form, this pinion suits many 1/10 electric touring and off road cars, giving a useful balance between acceleration and top end for varied track conditions.

How do I confirm this pinion will fit my motor shaft?

Check the motor shaft diameter and the pinion bore size. If needed, measure the shaft with calipers or consult your motor specs to ensure a match.

What routine checks should I do after fitting?

Verify gear mesh, tightness of the grub screw and inspect teeth for signs of abnormal wear after the first few runs.

Will this suit both touring and buggy setups?

Yes, it fits many 1/10 touring and 1/10 off road vehicles that use 48 pitch gear trains; check chassis clearance and spur compatibility.

Can I reuse my old spur with this pinion?

If the spur is 48 pitch and in good condition, it will work fine. Replace the spur if teeth are worn or damaged for best results.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved