3RACING 48 Pitch Spur Gear 95T - 3RAC-SG4895 On-Road Tuning Gear  [3RAC-SG4895]

3RACING 48 Pitch Spur Gear 95T - 3RAC-SG4895
Price:
NZD$7.56
Brand:
3Racing
Model:
3RAC-SG4895
Condition:
Brand New
Write a review

Dial In Final Drive with a 48 Pitch Spur

The 3RACING 48 Pitch Spur Gear 95T is a smart pick for modelers wanting reliable gearing behaviour. Intended for 1/10 scale on-road cars, the 95-tooth spur helps balance throttle feel and sustained speed across different track conditions.

Why the 95T Works Well

This gear offers predictable performance so your car keeps a steadier pace through a race. The 95T choice is a practical middle ground for those seeking usable acceleration without too much sacrifice to top-end pace.

Installation Notes and Compatibility

Fitting the 3RACING 48 Pitch Spur Gear 95T is typically straightforward on standard 1/10 chassis. It installs into common spur and pinion arrangements and is a direct swap in most cases, making it a simple upgrade option.

Do I need a new pinion to use this spur?

You can often reuse your current pinion if it is 48 pitch compatible, but check tooth count and mesh to ensure correct engagement and avoid binding.

Is 48 pitch common on modern 1/10 cars?

Yes, 48 pitch remains a standard for many 1/10 on-road kits and aftermarket parts, giving a good balance of strength and fine ratio control.

How do I check correct mesh?

Set gear mesh with a strip of paper between pinion and spur, then tighten and remove the paper. Look for even tooth contact and slight clearance to avoid binding.

Will this spur handle brushless power?

It will suit many brushless setups when used within normal power ranges for 1/10 on-road cars, but monitor heat and wear on high power systems.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved