3RACING 3RAC-PG6436 36T 64 Pitch Hard Coated 7075 Pinion  [3RAC-PG6436]

3RACING 64 Pitch Pinion Gear 36T (7075 w/ Hard Coating) - 3RAC-PG6436
Price:
NZD$6.53
Brand:
3Racing
Model:
3RAC-PG6436
Condition:
Brand New
Write a review

High Quality 64 Pitch 36T Pinion Gear

The 3Racing 64 Pitch Pinion Gear 36T uses 7075 aluminium with a hard coating to extend service life and preserve accurate tooth profile. It is aimed at hobbyists seeking dependable gearing for club racing and weekend bashing.

What the Material Brings

7075 is prized for strength and low weight, and the hard finish helps resist scuffing and wear during normal use. This makes the pinion a sensible choice where consistent mesh matters.

Applications and Setup Tips

Compatible with vehicles running 64 pitch gear trains, this 36T pinion is suitable for tuning gear ratios and refining acceleration or top speed. Always check mesh and alignment when installing.

How do I check gear mesh with this pinion?

Fit the pinion, hold the spur in mesh, and use a shim or paper method to set a small clearance across the teeth; then secure the pinion and recheck after a short run.

Can I use this with both brushed and brushless motors?

Yes, the pinion works with either motor type as long as the shaft fit and pitch match the rest of your drivetrain.

Should I lubricate this pinion?

Light gear grease on the spur interface can reduce friction, but avoid heavy build up which could attract debris.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved