3RACING 64 Pitch 55T Hard Coated Pinion Gear 7075 - 3RAC-PG6455 [3RAC-PG6455]

3RACING 64 Pitch Pinion Gear 55T (7075 w/ Hard Coating) - 3RAC-PG6455

Price:

NZD$7.57

Brand:

3Racing

Model:

3RAC-PG6455

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Performance 3RACING 64 Pitch Pinion Gear 55T

The 3RACING 64 Pitch Pinion Gear 55T combines strong 7075 aluminium with a hard coating to extend service life. It is a practical upgrade for modelers who run frequent sessions and want consistent drivetrain behaviour.

Notable characteristics

Material: High-strength 7075 aluminium gives a good strength to weight ratio for spirited driving.
Coating: Hard finish helps reduce abrasive wear on tooth faces during long runs.
Compatibility: Suited for models that require a 64 pitch pinion gear specification.

When to choose this gear

Install this pinion for reliable performance in club racing or trail bashing where gear durability matters. It holds up well under higher torque and repeated use.

Can I use this pinion on a nitro or electric motor?

Yes, it fits both nitro and electric setups provided the model uses a 64 pitch gear train and the shaft diameter matches your motor pinion mount.

Is there any break-in required?

No special break-in is needed. After installation, check mesh and run at low speed to confirm alignment before full-power use.

Does the coating affect durability in wet conditions?

The hard coating adds surface resistance to wear but is not a corrosion seal. Rinse and dry components after wet runs to keep the drivetrain in good condition.