3RACING 3RAC-PG6464 Hard Coated 7075 64 Pitch 64T Pinion  [3RAC-PG6464]

3RACING 64 Pitch Pinion Gear 64T (7075 w/ Hard Coating) - 3RAC-PG6464
Price:
NZD$7.57
Brand:
3Racing
Model:
3RAC-PG6464
Condition:
Brand New
Write a review

Built for Consistent Gear Engagement

The 3RACING 3RAC-PG6464 64 Pitch Pinion Gear 64T is engineered to give repeatable tooth contact in 1/10 scale electric cars. Its 7075 aluminium body with a protective hard coat helps maintain reliable performance over time.

Benefits of 7075 Aluminium

Using 7075 aluminium keeps the part light while offering strong resistance to impact and fatigue. The hard coating further shields the teeth from abrasive wear during long running periods.

Ideal for Fine Tuning

A 64 pitch, 64 tooth pinion is intended for drivers focused on precise gearing adjustments. This configuration supports smooth meshing and reduced gear whine when paired with matching spurs.

Practical Fit and Care

Check gear alignment and backlash after installation to avoid premature wear. Clean debris from the gearbox and inspect tooth faces after off-road or abrasive track sessions to ensure longevity.

Can I use this pinion on touring and pan cars?

Yes, it is suitable for many 1/10 touring and pan car setups that accept 64 pitch gears, particularly where fine gear ratios are needed.

How often should I inspect the gear?

Inspect after any heavy session or if you notice increased noise. Regular checks every few runs help catch wear early and protect other drivetrain parts.

Is the bore compatible with standard pinion shafts?

The pinion is made to match common 1/10 pinion shafts. Verify shaft diameter and set screws to ensure a snug, concentric fit before hard running.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved