3RACING 3RAC-SG64112/V3 112T 64 Pitch Spur Gear - Track Edition  [3RAC-SG64112/V3]

3RACING 64 Pitch Spur Gear 112T Ver.3 - 3RAC-SG64112/V3
Price:
NZD$7.56
Brand:
3Racing
Model:
3RAC-SG64112/V3
Condition:
Brand New
Write a review

High-Precision Spur Gear

The 3RACING 64 Pitch Spur Gear 112T Ver.3 is aimed at model racers wanting tight ratio control. Its tooth profile is tuned to give smooth torque transfer and predictable drivetrain response on a variety of surfaces.

Model Compatibility

Compatible with many 1/10 scale cars, this 112T spur gives extra options when adjusting final drive ratios. It works well for users refining handling for different track conditions or racing formats.

Setup Advice

Installation is straightforward: set the mesh with minimal play and verify alignment. Periodic cleaning and a light application of lubricant will keep the gear running quietly and extend its service life.

Will this change my top speed noticeably?

Changing to a different spur tooth count will alter final drive ratios; the 112T gives more resolution for tuning top speed versus acceleration depending on your pinion choice.

Is it noisy compared to coarser pitch gears?

A well-set 64 pitch mesh runs quietly. Noise usually comes from poor mesh or worn teeth rather than pitch alone.

Can I shim the mesh to reduce backlash?

Yes, shimming and careful pinion alignment are effective ways to tighten mesh without introducing binding.

What maintenance interval is typical?

Check mesh and clean debris after a few runs, and inspect teeth monthly if you race frequently. Replace the spur at the first sign of tooth deformation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved