3RACING 3RAC-SG64118/V2 118T 64 Pitch Spur Gear - Allrounder  [3RAC-SG64118/V2]

3RACING 64 Pitch Spur Gear 118T Ver.2 - 3RAC-SG64118/V2
Price:
NZD$7.57
Brand:
3Racing
Model:
3RAC-SG64118/V2
Condition:
Brand New
Write a review

Gear accuracy and match for 3RACING 3RAC-SG64118/V2

The 3RACING 3RAC-SG64118/V2 offers hobbyists an affordable way to refine gear timing and drivetrain feel. It is aimed at users seeking steady performance without complex modifications.

Use cases on road and trail

Built for 1/10 scale cars, this 118 tooth 64 pitch spur gives reliable torque distribution that suits both smooth circuits and mixed-surface outings. It helps keep handling predictable across different surfaces.

Simple installation advice

Installation is direct on vehicles that run 64 pitch gearsets. Ensure correct pinion alignment and check for any burrs on the shaft or gear that could affect mesh. Periodic checks will extend the component life.

Will this fit club-level 1/10 buggies?

Yes, many club-level 1/10 buggies using 64 pitch drivetrains can accept this spur, though you should double-check spline counts and gearbox clearance first.

Is any special tooling needed to install it?

No special tooling is required beyond standard RC maintenance tools such as hex drivers and a feeler for mesh adjustment; a gear puller is not usually needed.

How often should I inspect the spur?

Inspect the spur after high-load sessions and every few runs during break-in; look for chipped teeth, uneven wear or signs of overheating on the surface.

Can I change gear ratio by swapping pinion only?

Yes, altering the pinion tooth count is the usual way to tune final ratio with this 118T spur; just ensure the new pinion is 64 pitch to match.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved