3RACING 64 Pitch 97T Spur Gear - 3RAC-SG6497 - Track Tuning Spur  [3RAC-SG6497]

3RACING 64 Pitch Spur Gear 97T - 3RAC-SG6497
Price:
NZD$7.62
Brand:
3Racing
Model:
3RAC-SG6497
Condition:
Brand New
Write a review

Dial In Gear Precision

The 3RACING 64 Pitch 97T Spur Gear 3RAC-SG6497 provides accurate tooth spacing and steady operation for hobbyists refining drive performance. Built for dependable meshing, it helps maintain smooth power transfer in daily running and race practice.

Suitable Models and Use

This 97-tooth spur fits a wide range of 1/10 scale cars and is a dependable choice when adjusting ratios to favour control or top speed. The 64 pitch format gives finer tooth contact with compatible pinions, which helps keep friction and wear down.

Practical Setup Tips

For best results with the 3RACING 64 Pitch 97T Spur Gear, set the gear mesh with a thin paper feeler so the spur and pinion sit with minimal clearance. Proper alignment avoids chipped teeth and improves drivetrain quietness.

Can I use this gear for club level racing?

Yes, this spur is suited to club racing where consistent gear contact and predictable ratios are important. Match it with a compatible 64 pitch pinion for best results.

Will a 64 pitch gear wear faster than coarser pitches?

Not necessarily. A correctly set 64 pitch mesh spreads load across more teeth, which can reduce stress and extend life compared to poorly set coarser gears.

Do I need special tools to fit this spur?

Basic hand tools and a feeler for mesh are sufficient. Use a screwdriver, motor mount adjustment and a thin paper strip to set an appropriate gap before tightening hardware.

Is lubrication required on the gear teeth?

Light gear lubricant can reduce noise and wear in high hour use, but many racers run without grease to avoid attracting debris. Choose based on your running conditions.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved