3Racing SAK-A515/V2 Lightweight Rear Hub Carrier for Sakura Advance 21  [SAK-A515/V2]

3RACING Advance 21 Aluminum Rear Hub Carrier - SAK-A515/V2
Price:
NZD$32.65
Brand:
3Racing
Model:
SAK-A515/V2
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - 3Racing - Sakura Advance 21 category
Write a review

Tuned Stability with the 3Racing SAK-A515/V2

The 3Racing SAK-A515/V2 rear hub carrier is developed to reinforce the Sakura Advance 21 rear suspension while keeping weight low. It delivers a firmer mounting point that translates to more consistent yaw control during corner exits.

Lightweight Alloy for Track Use

Made from a resilient aluminum alloy, this carrier aims to reduce unwanted flex without adding bulk. Drivers will notice steadier feedback and improved balance when pushing lap pace.

Straightforward Fitment

Engineered for direct replacement on the Sakura Advance 21, the part aligns with existing suspension geometry for a hassle free swap. Basic hand tools are sufficient for fitting and initial setup checks.

Can I use this carrier with aftermarket uprights?

Compatibility depends on the upright design; check mounting hole patterns and clearances before pairing with non standard components.

Will the carrier change rear roll characteristics?

A stiffer carrier can reduce chassis flex at the rear, which may tighten turn in and alter mid corner behaviour. Small setup tweaks can rebalance handling.

How long does installation usually take?

An experienced hobbyist can swap the carrier in around 20 to 30 minutes, including basic alignment checks after installation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved