3Racing Sakura Advance 21M Front Spool Outer Joint SAK-A568A Performance Part  [SAK-A568A]

3RACING Advance 21M Front Spool Outer Joint - SAK-A568A
Price:
NZD$21.65
Brand:
3Racing
Model:
SAK-A568A
Condition:
Brand New
Write a review

Precision Spool Joint for Sakura Advance 21M Setups

The 3Racing Sakura Advance 21M Front Spool Outer Joint (SAK-A568A) is engineered to refine power transfer and match the Sakura Advance 21 platform, helping drivers keep predictable steering and traction at race pace.

Reliable Under Race Loads

Selected for strength and wear resistance, this outer joint is built to perform through repeated high-stress sessions, maintaining drivetrain smoothness and reducing play.

Suited to Track Tuning

Favoured by tuners and weekend competitors, this component works well for both set-up tweaks and regular replacement to retain peak chassis behaviour.

Can I run this on older Sakura Advance cars?

This part is tailored to the Sakura Advance 21M geometry. Older cars might need fit checks or different link lengths to install it correctly.

Does it require special tools to fit?

No specialised machinery is required; common RC hand tools are enough. Take care aligning the spool during reassembly for smooth operation.

How should I inspect it after running?

Inspect for visible wear, check for any side play and ensure fasteners remain tight. Clean and relubricate junctions as part of routine service.

Will this change handling balance?

It can alter front-end response by delivering more consistent drive to the front wheels; use it alongside suspension and toe settings when tuning balance.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved