Kyosho Cactus 2WD 24T Idler Gear 3Racing CAC-110 Precision Fit  [CAC-110]

3RACING Cactus 2WD 24T Idler gear - Kyosho CAC-110
Price:
NZD$3.27
Brand:
3Racing
Model:
CAC-110
Condition:
Brand New
Write a review

Refined drivetrain control for Cactus models

Swap in the Kyosho Cactus 2WD 24T Idler Gear by 3Racing CAC-110 to sharpen drivetrain feel and reduce gear lash. The component suits hobbyists who want a dependable upgrade for club racing and recreational use.

Durable profile for repeated heats

Manufactured with an emphasis on wear resistance and consistent engagement, the 24T idler keeps performance steady across multiple runs and varied track conditions. It holds up well under frequent use.

Plug and play Cactus compatibility

Designed to match Kyosho Cactus geometry, the idler fits without chassis modification so you can improve drivetrain efficiency with minimal setup time.

Do I need special tools to install this idler?

Basic hobby tools like screwdrivers and a gear mesh gauge are sufficient; no specialised machining is required for installation.

Should I use grease on the idler bearings?

Apply a light amount of gear grease or recommended lubricant to bearings and contact points to reduce wear and noise. Avoid excess grease that can attract dirt.

Is this part suitable for both racing and bashing?

The design copes with rougher surfaces, but after heavy impacts you should inspect teeth and bearings for damage. It is optimised for performance rather than extreme bashing.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved