3Racing CAC-308 Cactus 2WD Rear Shock Tower - Aluminium Mid Motor Part  [CAC-308]

3RACING Cactus 2WD Aluminum Rear Shock Tower For Mid Motor for Cactus - CAC-308
Price:
NZD$34.59
Brand:
3Racing
Model:
CAC-308
Condition:
Brand New
Write a review

Stiffen the Rear End of Your Cactus 2WD

The 3Racing Cactus 2WD Aluminium Rear Shock Tower CAC-308 is crafted for the Cactus 2WD mid-motor arrangement. This upgrade strengthens the rear mounting area to keep suspension geometry stable under load, helping your car stay composed across bumpy sections.

Why Aluminium Works Well on RC Cars

Aluminium offers robust support without adding excessive mass, helping parts resist wear from repeated impacts. The 3Racing tower balances toughness and lightness so handling stays sharp while durability improves.

Designed for Direct Replacement

Built to the Cactus 2WD mounting spec, the CAC-308 installs with minimal fuss. The precise fit reduces setup time so you can concentrate on damping and roll centre tweaks.

Can I fit this to a regular motor Cactus?

This part is intended for the mid-motor Cactus 2WD layout. If your chassis is a different motor position you may need modifications to obtain a correct fit.

Will using aluminium change crash behaviour?

Aluminium reduces flex at the shock mounts, which can make impacts transfer differently. Many hobbyists prefer this for predictable handling, but check other chassis settings after fitting.

Any corrosion care needed?

Aluminium is corrosion resistant but keep fasteners clean and use light oil on steel screws if you run in wet or salty conditions.

Does this require new shocks?

The tower uses existing shock mount locations so you can reuse your shocks, though you may retune valving or spring rate to suit the stiffer mount.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved