3RACING Cero Outer Shaft Hub 3mm SAK-C142 Replacement Part  [SAK-C142]

3RACING Cero Outer Shaft_Hub_3mm - SAK-C142
Price:
NZD$17.47
Brand:
3Racing
Model:
SAK-C142
Condition:
Brand New
Write a review

Compact Spare for Cero Drivetrains

The 3RACING Cero Outer Shaft Hub 3mm (SAK-C142) serves as a straightforward replacement for Cero assemblies, helping to reduce slop and restore correct shaft engagement. It is suitable for routine upkeep and occasional component swaps.

Design and Compatibility

Produced by 3RACING to match Cero kit geometry, this 3mm hub is intended to sit cleanly on the mating shaft without extra modification. It is a direct-fit option for standard Cero parts.

Quick Install Guidance

Installation is simple for hobbyists comfortable with basic maintenance. Ensure the shaft is clean and free of debris before fitting the hub to maintain smooth power transfer across the drivetrain.

Help and Advice

Can I reuse the original retaining hardware with SAK-C142?

In most cases the original screws and clips can be reused, but check for thread wear and replace any fasteners that show damage.

Will the hub affect handling?

A correctly fitted hub helps maintain consistent drivetrain response; handling changes are most likely due to wear elsewhere rather than the hub itself.

Is any prep required before fitting?

Clean the shaft and inspect bearings and seals. A light wipe and inspection prevent trapped grit from causing premature wear.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved