3Racing Cero Sport Graphite Rear Body Plate for Setup - Factory Pro O-3CKP03  [FP-O-3CKP03]

Factory Pro FP-O-3CKP03 Rear Body Mount Plate - Graphite (for 3racing Cero Sport Series)
Price:
NZD$11.73
Brand:
Factory Pro
Model:
FP-O-3CKP03
Condition:
Brand New
Write a review

Overview of the rear body plate

This Factory Pro upgrade is produced for the 3Racing Cero Sport series to replace the rear body mount interface, using graphite to provide added stiffness and a reliable seating surface for the rear body shell. The component sits around the rear body post area and is intended to be used with the chassis's supplied body posts and clips.

Fitment is straightforward for those used to 3Racing assemblies: remove the standard rear body mount hardware, align the graphite plate over the rear mounts, and secure it using the existing fasteners. The plate is aimed at setup consistency rather than cosmetic changes, helping to keep body alignment stable during setup and after multiple removals.

Is this compatible with aftermarket body posts?

It works with the standard rear post locations on 3Racing Cero Sport cars; if you use non-standard posts check clearances and hole alignment before installing.

Will it affect weight or balance?

The plate adds a small amount of material at the rear but is primarily chosen for stiffness and alignment rather than weight tuning, so any change to balance is minimal.

How long does fitting usually take?

For a modeller familiar with the chassis, removal and refit using the original fasteners typically takes only a few minutes per car.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved