3RACING CRA-126 Crawler Ex 27mm Axle Tube Reinforcement  [CRA-126]

3RACING Crawler Ex Real Axle Wall Tubing 27mm - CRA-126
Price:
NZD$8.60
Brand:
3Racing
Model:
CRA-126
Condition:
Brand New
Write a review

Solid 27mm Axle Tube for Off-Road Lines

The 3RACING CRA-126 Crawler Ex Real Axle Wall Tubing gives your crawler a firmer axle core that helps when you are threading through technical lines. This 27mm diameter part is matched to Crawler Ex layouts for reliable installation and improved on-trail behaviour.

Notable Qualities of the 3RACING Tube

  • Compatibility: Specifically matched to Crawler Ex platforms to minimise fitment work.
  • Durability: Designed to stand up to abrasive trail use and repeated impacts.
  • Precision Fit: Engineered to install cleanly, helping keep setup time to a minimum.

Why Install This Axle Tubing

Upgrading to the 3RACING CRA-126 can reduce axle flex and improve steering predictability, making it easier to place your crawler on difficult obstacles. It is a straightforward upgrade for hobbyists aiming for steadier trail performance.

Does this axle tube require special tools to fit?

No special tools are normally required; basic axle assembly tools and a careful mock up are enough for most installations.

Will this change suspension travel or geometry?

The tubing keeps original geometry when fitted correctly, though small clearances should be checked to ensure full articulation on extreme flex.

How should I maintain these tubes?

Inspect for dents or corrosion after hard runs, clean contact areas, and replace if the tube shows permanent deformation that could affect axle alignment.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved