3RACING CRA-110 Crawler Ex Real 2-Speed 34T Replacement Gear  [CRA-110]

3RACING Crawler Ex Real 2 Speed Bearing Gear 34T - CRA-110
Price:
NZD$6.54
Brand:
3Racing
Model:
CRA-110
Condition:
Brand New
Write a review

Improve Two-Speed Drivetrain Control with 3RACING CRA-110

The 3RACING Crawler Ex Real 2 Speed Bearing Gear 34T, model CRA-110, serves as a dependable replacement or upgrade for Crawler Ex Real drivetrains. It focuses on delivering steady torque transfer for better control on technical sections.

Durability for Trail Sessions

Designed with trail use in mind, the 34T gear from 3RACING is intended to endure typical crawling stresses encountered during rock and root runs. Its build helps reduce wear cycles so the gear keeps performing over time.

Installation Notes and Fit

The CRA-110 is made to match the Crawler Ex Real mounting and spline pattern, enabling direct replacement without major alterations. Follow standard installation checks to ensure smooth meshing and alignment.

Is the CRA-110 suitable for competition crawling?

Yes, for many club-level crawler classes the CRA-110 provides reliable gearing behaviour, though final performance depends on motor, pinion and diff setup.

Will the 34T gear affect top speed on the highway?

This gear is tuned for crawling and low speed control rather than top speed. Expect minimal impact on high speed runs if used within a two-speed drivetrain designed for crawling.

How often should I inspect the gear?

Inspect the gear after intense trail sessions or if you notice noise or slop in the drivetrain. Regular checks help catch wear before it affects performance.

Are replacement bearings needed when changing the gear?

If the original bearings show wear, replace them during installation for best long term performance. Healthy bearings support smooth gear operation.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved