3RACING ST-004/BL Droop Gauge Black Edition For Club Racers  [ST-004/BL]

3RACING Droop Gauge -4 to 10mm - Black - ST-004/BL
Price:
NZD$13.17
Brand:
3Racing
Model:
ST-004/BL
Condition:
Brand New
Write a review

Dial in Droop with the 3RACING ST-004/BL

The 3RACING Droop Gauge is built to help model drivers measure suspension droop from -4mm up to 10mm with confidence. It simplifies setup checks so you can focus on fine tuning suspension behavior.

Practical, Track-Ready Construction

The black coating on the 3RACING ST-004/BL resists grime and keeps the tool looking tidy after repeated pit use. Its slim footprint makes it straightforward to slip into your tool roll and bring to events.

Works Across Multiple Surface Types

Use the gauge to adjust for loose off-road tracks or precise tarmac corners; consistent droop measurement helps you balance understeer and oversteer tendencies. Accurate readings speed up setup comparisons between runs.

What is the best routine for using the droop gauge?

Start with the car on its wheels, place the gauge under the arm pivot, and move the arm to match the desired reading. Repeat checks after any suspension change.

Can I use this on converted or custom suspension setups?

The ST-004/BL suits many setups but verify that arm clearance and pivot height allow the gauge to seat correctly before relying on its readings.

Any tips for consistent results?

Take measurements on a flat surface, use the same tyre pressures and ride height, and document settings so you can repeat proven setups.

Does the gauge need calibration?

The tool is ready to use out of the box; check it visually for flatness and keep it clean to maintain accurate readings.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved