3RACING Titanium Droop Gauge -4 to 10mm ST-004/TI - Track Setup Gauge  [ST-004/TI]

3RACING Droop Gauge -4 to 10mm - Titanium - ST-004/TI
Price:
NZD$13.17
Brand:
3Racing
Model:
ST-004/TI
Condition:
Brand New
Write a review

Accurate droop measurements with the 3RACING ST-004/TI

The 3RACING Titanium Droop Gauge -4 to 10mm ST-004/TI is a purpose-built titanium gauge for measuring suspension droop. Its -4 to 10mm range helps you quickly confirm ride height and suspension travel for race and practice sessions.

When to use this gauge

Fit the gauge into your setup routine when balancing corner entry and exit behaviour. Precise droop readings let you compare different spring or damper setups and tune the car to suit varying track surfaces.

Lightweight titanium for convenience

Thanks to titanium construction, the gauge stays light in the pit bag while offering good durability. It handles repeated checks and transport without significantly adding to kit weight.

Can I use this on smaller or larger scales?

The gauge is optimised for 1/10 scale setups, but it can be useful on other scales if your suspension droop sits inside the -4 to 10mm window.

Best practice for measuring droop?

Set the car on a flat surface, place the gauge at the reference point, and slowly compress or extend the suspension to the target reading. Record values on both sides to check symmetry.

Will the gauge markings wear out?

Titanium resists wear, but avoid scraping the edges on abrasive surfaces. Clean it after runs to keep measurements clear and reliable.

Is this suitable for quick pit checks?

Yes, its compact size and clear range make it useful for fast checks between heats or practice laps to ensure consistent setup.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved