3Racing SAK-D626A Sakura D6 Rear Belt Bulkhead - Aluminium Strength  [SAK-D626A]

3RACING KIT-SAKURA D6 Belt Rear Bulkhead - SAK-D626A
Price:
NZD$10.91
Brand:
3Racing
Model:
SAK-D626A
Condition:
Brand New
Write a review

Fit the 3Racing SAK-D626A to Boost Sakura D6 Rear Stability

The 3Racing SAK-D626A Rear Belt Bulkhead is engineered for the Sakura D6 chassis and uses robust aluminium to reinforce the rear structure. It improves the rear end rigidity and helps the car feel more composed through corners. A sensible upgrade for weekend racers and hobbyists who want consistent handling.

Robust Construction for Consistent Response

Produced from reliable aluminium, the 3Racing SAK-D626A Rear Belt Bulkhead increases durability where the belt and drivetrain mount. Keeping components firmly located reduces unwanted movement and supports cleaner power transfer to the wheels. The exact fit aids alignment so setup changes behave predictably.

Key Benefits and Installation Notes

  • Material: Quality aluminium for dependable service
  • Compatibility: Specifically matched to the Sakura D6 chassis
  • Functionality: Adds rear drivetrain stability and sharper handling feel
  • Installation: Simple swap for common RC toolkits

Can I use this with modified rear mounts?

If your rear mount layout follows the Sakura D6 standard, the SAK-D626A should fit. Custom or heavily modified layouts may need measurement before purchase.

How long does installation take?

For an experienced builder the swap can take under 30 minutes. Allow extra time if you need to check belt alignment and adjust settings.

Is any break in required after fitting?

No formal break in is needed, but inspect mounting screws and belt tension after a short test run to confirm everything is seated correctly.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved