3RACING Precision M5.8 x 7.5mm Ball Stud 3mm Hole - 3RAC-BS5875  [3RAC-BS5875]

Precision Ball Studs to Improve Handling Feel

The 3Racing M5.8 x 7.5mm Ball Stud with a 3mm hole helps tighten up suspension link geometry and improves predictability in turns. It is a simple part that can sharpen the feedback from your chassis.

Where to Use Them

These ball studs work well across a variety of small scale RC rigs and provide firm, repeatable connection points. They are a practical choice when you want to fine-tune steering and roll behaviour without major parts changes.

Fitting Advice for Hobbyists

Fit the 3Racing studs with even torque so linkages move freely but without side-to-side play. Check for correct alignment after a few runs and address any looseness promptly to keep handling consistent.