3Racing MIF-015/TI Kyosho Mini Inferno Rear Brace Stiffener  [MIF-015/TI]

Rear chassis brace for Mini Inferno

This silver-finished rear brace stiffener is made for the Kyosho Mini Inferno and Mini Inferno ST and carries the model reference MIF-015/TI. It attaches at the factory rear brace points to provide a more rigid rear section when adjusting vehicle balance.

Compatibility is confined to the named models and installation uses the original mounting points. No chassis cutting is required beyond removing the stock brace, but check that the unit sits flush before locking down screws.

In tuning terms, the stiffener changes load transfer through the rear suspension and diff, so you may need to tweak damper settings or tyre selection to restore the desired balance. Apply setup changes gradually and record results.

Fitment notes: use a tidy work area and standard hex drivers, retain original screws where possible, verify threads during reassembly, and avoid excessive torque that could damage components.