3Racing SAK-MG41 Sakura Mini MG Rear Pin Upgrade  [SAK-MG41]

3Racing Sakura Mini MG Rear Suspension Outer Pin Set (M2.6 x 25mm) - SAK-MG41
Price:
NZD$4.19
Brand:
3Racing
Model:
SAK-MG41
Condition:
Brand New
Write a review

Rear Pin Set Tailored to Sakura Mini MG

The 3Racing SAK-MG41 Rear Suspension Outer Pin Set is produced to match the Sakura Mini MG specification with M2.6 x 25mm pins for an accurate fit. These components are intended to increase the robustness and dependability of the rear suspension assembly.

Reliable Construction for Track Use

These pins are produced from sturdy metal to keep the suspension joint secure during spirited driving. The chosen M2.6 x 25mm dimensions provide resistance to wear while keeping necessary movement for effective damping.

Straightforward Swap for Improved Handling

As a direct replacement for worn parts, these rear suspension pins make it simple to maintain handling consistency. They support cleaner rear responses which helps when dialing in corner exits and balance.

Will these affect rear roll characteristics?

The pins themselves maintain the intended geometry; any change to roll behaviour is usually from worn or loose parts being replaced, resulting in more consistent response rather than altering roll rate.

Are special fittings required for installation?

No special fittings are needed for a proper install on a Sakura Mini MG. Standard small hand tools and a steady hand are sufficient to seat the pins correctly.

Do these pins need lubrication?

A light application of appropriate lubricant at pivot points can reduce wear and noise, but avoid heavy grease that may attract grit and accelerate wear.

Can I reuse old retaining hardware?

If the retaining clips or screws show no deformation or corrosion they can be reused, but inspect them and replace any hardware that shows signs of fatigue.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved