3Racing SAK-A534 Sakura Advance 2K18 EVO Brass Spacer Kit - Low CG Upgrade  [SAK-A534]

3Racing Sakura Advance 2K18 EVO Touring Chassis M5 x 7 X 1.5 Brass Spacer For Advance 2K18 - SAK-A534
Price:
NZD$6.54
Brand:
3Racing
Model:
SAK-A534
Condition:
Brand New
Write a review

Refine Sakura Advance 2K18 EVO handling with brass spacers

If you tune setups by feel, the 3Racing SAK-A534 Brass Spacer is a useful addition. Tailored for the Sakura Advance 2K18 EVO touring chassis, the M5 x 7 x 1.5 spacer gives a consistent fit and extra mass to improve composure when pushing pace.

Why brass helps chassis balance

Brass adds reliable weight and toughness compared with lighter materials, aiding a lower center of gravity and steadier transitions. This 3Racing component is machined to match the Sakura Advance layout and maintain alignment under load.

Fitting notes for quick upgrades

Installation is a direct swap: remove the original spacer, fit the 3Racing M5 x 7 x 1.5 spacer, then recheck clearances and torque. It is ideal for drivers refining balance at club meetings or practice sessions.

Can I mix brass and aluminium spacers?

Mixing materials is possible but alters weight distribution. Use consistent spacer stacks where possible to avoid unpredictable balance shifts.

Do I need different spacers for front and rear?

It depends on your setup goals. Brass at the front can reduce understeer, while rear mass changes can affect traction; test one change at a time.

Is thread locker recommended?

Use a light thread locker for high-vibration applications, but avoid overuse to keep future disassembly simple.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved