3Racing SAK-D313/V2/PK Sakura D3 CS SPORT Rear Bulkhead Housing Performance Piece  [SAK-D313/V2/PK]

3RACING Sakura D3 CS SPORT Aluminum Rear Bulkhead Bearing Housing - SAK-D313/V2/PK
Price:
NZD$28.65
Brand:
3Racing
Model:
SAK-D313/V2/PK
Condition:
Brand New
Write a review

Strengthen Your Sakura D3 with an Aluminium Rear Bulkhead

The 3Racing SAK-D313/V2/PK is an aluminium rear bulkhead bearing housing tailored for the Sakura D3 CS SPORT chassis. It brings added toughness and better bearing seating to reduce play and help preserve drivetrain alignment under load. This part is aimed at hobbyists who run frequent sessions and want dependable hardware.

Why Aluminium Works Well

Aluminium combines resilience with low mass, helping to cut down on deformation and wear where plastic parts might fatigue. Using the 3Racing SAK-D313/V2/PK can deliver steadier rear-end behaviour and longer service intervals for club and practice runs.

Simple Installation for Direct Replacement

Engineered to match Sakura D3 CS SPORT dimensions, the 3Racing SAK-D313/V2/PK fits in place of the stock bulkhead with minimal adjustments. It is a practical swap for builders wanting a robust, maintenance-friendly upgrade.

Can I use my existing bearings and screws?

In most cases your current bearings and mounting screws will fit the 3Racing SAK-D313/V2/PK, but check for any signs of wear before reuse.

Does this help reduce drivetrain lash?

Improved bearing seating from the aluminium housing can reduce lateral play, which helps tighten drivetrain response under acceleration.

Is any setup change needed after fitting?

No major setup changes are required, though minor toe or shock adjustments may be used to fine tune handling after the upgrade.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved