3Racing SAK-D4830A/PK Sakura D4 Rear Camber Adjustment Plate - Drift Setup Piece  [SAK-D4830A/PK]

3RACING Sakura D4 RCM_Rear Camber Mixing Plate - SAK-D4830A/PK
Price:
NZD$21.68
Brand:
3Racing
Model:
SAK-D4830A/PK
Condition:
Brand New
1 Reviews
Write a review

Refine rear camber for cleaner slides

If you tune for consistent drift lines, the 3Racing SAK-D4830A/PK Sakura D4 Rear Camber Adjustment Plate provides precise camber adjustment that helps maintain tyre contact through slides. It is created for the Sakura D4 chassis so alignment changes are intuitive for experienced tuners.

Tailored integration with Sakura D4 components

The camber plate fits the Sakura D4 mounting pattern and keeps installation quick and predictable. Robust construction means it copes with hard sessions and retains its settings under lateral loads.

Reliable materials for frequent track use

Constructed from quality materials, the 3Racing camber plate resists deformation during repeated use. Its stability supports predictable handling so drivers can focus on setup fine tuning rather than component wear.

 

Product Reviews
1 Reviews
rating
They are awesome! You guys are awesome! Had what i needed and they arrived in a timely manner. No damage, etc. Would buy again, would recommend.

Does this require new bearings or hardware?

No special bearings are needed. The plate uses standard Sakura D4 hardware but check screws for length and thread fit during installation.

Can this help with rear grip on low traction surfaces?

Adjusting camber can change tyre contact patch and improve rear traction depending on setup. Use small incremental changes and test on your surface.

Is it compatible with aftermarket rear hubs?

Compatibility depends on hub design. Most stock-style hubs will work, but confirm bolt patterns and clearances if using low profile or custom hubs.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved