3Racing SAK-M4P09 Sakura M4 Pro Graphite Rear Shock Mount  [SAK-M4P09]

3Racing Sakura M4 Pro Rear Gaphite Shock Tower - SAK-M4P09
Price:
NZD$19.59
Brand:
3Racing
Model:
SAK-M4P09
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - 3Racing - Sakura M4 Pro category
Write a review

Refine Rear End Response on the Sakura M4 Pro

The 3Racing SAK-M4P09 graphite rear shock tower is tailored to the Sakura M4 Pro chassis to provide a tougher rear shock mount that resists flex under load. Its graphite composition focuses on delivering stability without a weight penalty.

Why Graphite Suits Road and Dirt

Graphite is prized in RC builds for combining low weight with good rigidity. Using a graphite tower helps keep the suspension geometry precise, which aids corner grip and consistency across laps.

Installation and Longevity Tips

For best results fit the 3Racing SAK-M4P09 with even screw torque and inspect after heavy use. Regular checks and correct tightening will keep the component performing well over time.

Can I run this tower on a tuned suspension setup?

Yes, the SAK-M4P09 works with standard Sakura M4 Pro suspension configurations and can benefit tuned setups by reducing mount flex.

How does graphite affect handling on rough surfaces?

Graphite keeps the mounting point rigid so the suspension can work more predictably over bumps, improving control on uneven surfaces.

Is special hardware required for installation?

Standard Sakura M4 Pro mounting hardware is normally used; follow manufacturer guidance and check screw lengths when fitting the tower.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved