3Racing SAK-U404/V2/BK Front Suspension Mount - Track Ready Sakura Ultimate  [SAK-U404/V2/BK]

3RACING Sakura Ultimate 7075 Aluminum Front Suspension Mount FF+2 Ver.2 - SAK-U404/V2/BK
Price:
NZD$21.91
Brand:
3Racing
Model:
SAK-U404/V2/BK
Condition:
Brand New
Write a review

Reinforced Front Bulkhead Solution

The 3Racing SAK-U404/V2/BK is a front suspension mount crafted from 7075 aluminum to replace the standard component on the Sakura Ultimate. Its accurate machining ensures clean alignment and helps the front suspension hold geometry during hard cornering and braking.

Main Benefits

  • Material: Durable 7075 aluminum for extended service life
  • Compatibility: Specifically matched to Sakura Ultimate chassis mounting points
  • Functionality: Boosts front-end stability and consistent handling
  • Installation: Straightforward installation with precise fitment

Who Should Fit This?

Racers and regular club drivers will notice steadier steering and less unwanted flex after fitting the 3Racing 7075 Aluminum Front Suspension Mount. It is a simple upgrade that supports consistent setup repeatability across multiple sessions.

Can I reuse my stock screws?

In most cases stock hardware will work, but confirm screw length to avoid protrusion into moving parts. Replace any damaged fasteners before final assembly.

Will this change suspension tuning?

The mount increases front stiffness which can affect handling balance. You may need small suspension adjustments such as roll centre or damping to restore your preferred setup.

Is additional maintenance required?

Inspect mounting hardware and surrounding chassis areas periodically for signs of wear or loosening, and re-torque screws after the first few runs.

Does it affect weight distribution?

The part adds a small amount of weight to the front, but the main benefit is improved rigidity rather than a large shift in balance.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved