3Racing 3RAC-BE4816/V3 4.8mm Ball Cup Kit 16mm  [3RAC-BE4816/V3]

4.8mm Ball Cap Set - 16mm/V3 - 3Racing 3RAC-BE4816/V3
Price:
NZD$3.27
Brand:
3Racing
Model:
3RAC-BE4816/V3
Condition:
Brand New
Write a review

Practical Ball Caps from 3Racing for Precise Tie-Rod Work

This 3Racing 4.8mm Ball Cap Set is built for modelers who perform frequent steering tweaks and suspension tune ups. It gives a reliable seating point for turnbuckles and rod ends when making small setup changes.

Consistent Connection for Linkages

The 4.8mm diameter ensures a snug interface with typical ball studs and keeps steering behaviour predictable. With a 16mm profile these caps suit many on-road and off-road link lengths.

Handy for Maintenance and Upgrades

Use the set to replace worn caps or to try different tie-rod lengths during setup trials. Its broad fit range makes it a useful item for routine maintenance and quick trackside repairs.

Can I use these on both front and rear linkages?

Yes, the 3Racing 4.8mm Ball Cap Set is versatile enough to be used on either front or rear tie-rod and turnbuckle connections where 4.8mm caps are required.

Will the 16mm length affect my geometry?

The 16mm length is a common size that keeps geometry changes minimal, but always check toe and steering angle after fitting to confirm desired alignment.

Do these come as a complete set for a car?

This set provides multiple 4.8mm ball caps suitable for replacing several worn pieces, but check quantities to match your specific vehicle needs.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved