56SR Replacement Cylinder Head Gasket - YSS2003 by YS Engine  [YSS2003]

YS ENGINE CYLINDER HEAD GASKET 56SR #S2003
Price:
NZD$5.49
Brand:
YS Engine
Model:
YSS2003
GTIN:
4560105741728
Condition:
Brand New
Write a review

Sealing and Fit for 56SR

The YS Engine YSS2003 head gasket is an RC-scale spare made for the 56SR series of model engines. It creates the seal between the cylinder head and cylinder, helping preserve compression and preventing combustion gas escape during rebuilds or routine checks.

When fitting this gasket, clean all mating surfaces, make sure the gasket sits flat, align the head correctly, and tighten screws in small increments using a crisscross sequence to reduce distortion. Avoid overtightening and follow any available service data for torque guidance.

Replace the gasket after any head removal, if compression drops, or when the part shows visible wear or deformation. Using the correct gasket helps keep compression steady for consistent tuning and reduces the chance of repeated adjustments.

Can this gasket be used on different engine variants?

YSS2003 is produced for the 56SR line; compare the gasket dimensions and bolt pattern with your engine before fitting to ensure proper fitment.

How do I prevent head distortion during assembly?

Tighten the head screws gradually and in a crisscross order, stopping as soon as the head seats. This controlled approach minimizes the risk of warping.

Is the gasket replaced at every tune?

You only need to replace the gasket when the head is removed or if you observe damage or loss of compression; routine tuning alone does not require a new gasket each time.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved