6mm Gold Damper Ball for Mini 4WD M4WD-04/GO by 3Racing  [M4WD-04/GO]

Tamiya Mini 4WD 6mm Damper Ball (gold) - 3RACING M4WD-04/GO
Price:
NZD$4.28
Brand:
3Racing
Model:
M4WD-04/GO
Condition:
Brand New
1 Reviews
Write a review

M4WD-04/GO 6mm gold damper ball designed for compact mass dampers

This 6mm gold damper ball is offered as an aftermarket mass-damper component for Mini 4WD assemblies. It matches typical 6mm damper housings and provides a compact weighted contact point intended to change inertial response in small damper systems.

Installation clearance is determined by the damper carrier and nearby chassis parts. Builders should measure the internal bore and confirm retainer fitment before installation. The part is supplied as a single ball and fits into existing damper assembly practice.

For care, keep contact areas clean and confirm retained clearance after assembly. The gold finish is cosmetic and may wear where contacted repeatedly; this note describes appearance and serviceability rather than claiming performance benefits.

 

Product Reviews
1 Reviews
rating
Excellent service, two of the items I purchased were out of stock but was given fair options on refund, store credit or replacement. I opted for replacement as there was a different version available and one of the items did arrive bent and they sent out

Which damper carriers accept this ball?

It is made for damper carriers with a 6mm internal diameter. Double-check your carrier bore and any retaining hardware to ensure a secure fit.

Will the gold plating change mass properties?

The finish is a surface treatment and primarily affects appearance. Mass and inertia come from the base metal; the coating should not be treated as a tuning specification.

Can I use this on vintage Mini 4WD parts?

Compatibility is case by case. If the vintage damper accepts a 6mm ball and has adequate retaining clearance, it can be used; always verify dimensions first.

How should I maintain the damper ball?

Keep the ball and housing free of grit and oil, inspect for finish wear, and replace if the surface becomes pitted or alters damper action. Routine checks maintain consistent behaviour.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved