74mm Swing Shaft for Universal/SB/ZX7.5 - Kyosho LAW92-01  [KY-LAW92-01]

Kyosho LAW92-01 - Swing Shaft (74mm/1pc/for Universal/SB/ZX7.5)
Price:
NZD$17.18
Brand:
Kyosho
Model:
KY-LAW92-01
GTIN:
4548565524624
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $14.62 each $5.10 or 15%
3+ $13.89 each $9.85 or 19%
Write a review

Component Summary

This is a single 74mm swing shaft supplied as 1 pcs intended for scale RC drivetrains. It is specified as compatible with Universal, SB and ZX7.5 platforms and helps restore correct driveline geometry when the original component is worn.

During installation verify axial alignment and that universal joints rotate without binding; check for adequate mounting bore clearance and that the shaft remains free through full suspension movement. Correct fitment supports steady power transfer and consistent handling characteristics.

The part is offered as a straightforward replacement for maintenance rather than a high-performance upgrade; confirm compatibility with your chassis and test fit before final reassembly.

Compatible Models

  • Universal
  • SB
  • ZX7.5

Keep this shaft as a spare to minimise workshop time when replacing worn drivetrain items.
Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What checks should I do before fitting the LAW92-01?

Measure mounting bore clearance, confirm overall length of 74mm, and inspect universal joint bores for wear before assembly.

Are any special tools required to fit it?

No specialised tools are necessary; basic workshop tools and a caliper for dimension checks are usually sufficient.

Can I reuse the existing universal joints with this shaft?

You can reuse universal joints if their bores are in good condition; replace any worn joints to avoid premature driveline issues.

How do I verify there is no binding after fitment?

Move the suspension through full travel and rotate connected joints by hand to confirm smooth operation before tightening final fasteners.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved