Align T-Rex 500 Skid Pipe Upgrade JR-HAG-TX500-042 by Jazrider  [JR-HAG-TX500-042]

This landing skid pipe serves as an aftermarket replacement for the Align T-Rex 500 skid assembly, referenced JR-HAG-TX500-042. It replaces a bent or worn tube and brings the landing gear back to correct geometry without affecting flight controls or rotor balance.

Make sure the skid dimensions match your T-Rex 500 frame before purchase. The part is intended to interface with the existing skid mounts and fasteners on the T-Rex 500 chassis and is not a universal fit.

To fit, remove the old pipe from the brackets, align the new tube in the same orientation and secure with the original hardware. Check the skid alignment on a level surface and perform a short hover inspection to confirm ground handling.

Using a correct replacement reduces uneven loading on touchdown and helps maintain consistent taxi and landing behavior. It is supplied as a maintenance spare rather than a tuning modification.

Compatible Models

• Align T-Rex 500