JAZRIDER JR-HAG-TX450-001T - Precision alloy seesaw for Align T-Rex 450 SE V2  [JR-HAG-TX450-001T]

Alloy Flybar Seesaw Hub Set For Align Trex T-rex 450 AE SE V2 Metal parts - Jazrider Brand [JR-HAG-TX450-001T]
Price:
NZD$9.94NZD$16.23
Brand:
JAZRIDER
Model:
JR-HAG-TX450-001T
Condition:
Brand New
Available in warehouse
Write a review

Refine your Align T-Rex 450 SE V2 head with an alloy seesaw

The JAZRIDER Alloy Flybar Seesaw Hub is engineered for the Align T-Rex 450 SE V2 to give a tougher, more reliable pivot point in the flybar system. The alloy build reduces flex and preserves alignment over repeated flights.

Advantages of choosing an alloy seesaw

An alloy seesaw tends to resist wear better than stock material, keeping the flybar geometry stable. That translates into more predictable cyclic response and less time spent chasing minor trim issues caused by component slop.

Compatibility notes and quick swap guidance

Designed as a direct replacement for the Align T-Rex 450 SE V2 part, this hub typically installs without modification. After fitting, verify collective and cyclic travel and make small adjustments to dial in neutral tracking.

Is the hub machined or cast?

This product is a precision alloy part intended to be more robust than common stock pieces. Surface finish and tolerances are intended for direct installation.

Will I notice a change in flight feel?

Expect a slightly firmer head feel and reduced micro-vibration. Handling should feel steadier, especially in sustained hover and gentle 3D moves.

Any setup tips after installing?

Re-check head geometry and blade tracking. Minor swash or gyro trim adjustments may be needed to restore perfect neutral behaviour.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved